Mineplayers foro

Test electrical wire for damages

0 Usuarios y 1 Visitante están viendo este tema.

Desconectado aaronpawlak

  • *
  • 14
  • 0
  • Mineplayer
    • Ver Perfil
  • Nickname Juego: aaronpawlak
Test electrical wire for damages
« en: Abril 24, 2018, 10:11:58 am »

I ran, through the basement joist, 12-2 NMD-90 wires for my heating system. I used a 5/8" drill bit to make the holes and ran two wires per hole.
One of the wire was really hard to pull and the cable jacket was stretched a lot (about a ft of stretch for a 30 ft run)
Should I test the wire with a megohmmeter to ensure that there is no damage made to it? If so at what voltage should I test it and what results should I expect?
Should I just replace the wire?

Please help.

I didn't find the right solution from the Internet.

Creative digital advertising studio